For
more information, refer to the General
recommendations on the use of driving
and manoeuvring aids.
This system prevents the vehicle
from
exceeding the speed programmed by the
driver (speed setting).
The speed limiter is switched on manually.
The minimum speed setting is 19 mph (30 km/h). The speed setting remains in the system memory when the ignition is switched off.
Steering-mounted control
Display the speed thresholds saved using the Memorising speeds function
or
Use the speed suggested by the Speed Limit Recognition and Recommendation (MEM display)
For more information on Memorising speeds or the Speed Limit Recognition and Recommendation, refer to the corresponding sections.
Information displayed on the instrument panel
Switching on/Pausing
When
the speed setting remains below
the vehicle's speed for a prolonged period
of time, an audible warning is emitted.
Adjusting the limit speed setting
You do not have to switch the speed limiter on in order to set the speed.
To modify the limit speed setting based on the vehicle’s current speed:
To change the limit speed setting using memorised speeds, via the touch screen:
The selection screen closes after a few moments. This setting becomes the new limit speed.
To modify the cruise speed setting based on the speed suggested by the Speed Limit Recognition and Recommendation, as shown on the instrument panel:
The speed is immediately shown on the instrument panel as the new speed setting.
Temporarily exceeding the speed setting
The speed limiter is temporarily deactivated and the displayed speed setting flashes.
When exceeding the speed is not due to the driver's action (e.g. in case of a steep slope), an audible signal is triggered immediately.
On a
steep descent or in the event of
sharp acceleration, the speed limiter will
not be able to prevent the vehicle from
exceeding the speed setting.
If necessary, apply the brakes to control your vehicle’s speed.
When the vehicle speed returns to the speed setting level, the speed limiter operates again: the speed setting display becomes fixed again.
Switching off
Turn the thumbwheel 1 to the "OFF" position: speed limiter information is no longer displayed.
Malfunction
Dashes are displayed (flashing, initially, then fixed) in the event of a speed limiter malfunction.
Have the system checked by a dealer or a qualified workshop.
In each mode, specific types of information are displayed on the instrument panel.