DS 3: Charging the traction battery (Electric) / Disconnection
DS 3 2016-2024 Owners Manual
Before disconnecting the nozzle from the
charging connector:
- If the vehicle is unlocked, lock it and then
unlock it.
- If the vehicle is locked, unlock it.
The red indicator lamp in the flap goes out to
confirm that the charging nozzle is unlocked.
- Within 30 seconds, remove the charging
nozzle.
The charging indicator lamp comes on in white.
With
selective door unlocking activated,
press the unlocking button twice to
disconnect the charging nozzle.
When
charging is complete, the green
charging indicator lamp in the flap goes
out after about 2 minutes.
Domestic charging, mode 2
The end of charging is confirmed when the green
CHARGE indicator lamp on the control unit and the
green charging indicator lamp in the flap come
on fixed.
- Replace the protective cover on the charging
nozzle and close the charging flap.
- Disconnect the control unit end of the
charging cable from the domestic socket.
Accelerated charging , mode 3
The end of charging is indicated by the charging
control unit and by the fixed lighting of the green
indicator lamp in the flap.
- Hang up the nozzle on the charging unit and
close the charging flap.
Superfast charging, mode 4
The end of charging is indicated by the charger
and by the fixed lighting of the green indicator
lamp in the flap.
- You can also pause charging
by
pressing this button in the flap (in mode 4
only).
- Hang up the nozzle on the charger.
- Depending on version, replace the protective
cover on the lower section and close the charging
flap.
Settings
On a smartphone or tablet (GSM), with DS
CONNECT RADIO or DS CONNECT NAV
You can programme the deferred
charging
function at any time via the MyDS
application...
Load distribution
Distribute the load in the trailer so that
the heaviest items are as close as possible to
the axle, and the nose weight approaches the
maximum permitted without exceeding it...
Other information:
In certain situations, it is necessary to put the
vehicle into free-wheeling mode (e.g. towing, on
a rolling road, automatic car wash (Wash mode),
rail or sea transport).
The procedure varies according to the type of
gearbox and parking brake.
With a manual gearbox and electric parking brake
To release them
With the engine running and while depressing
the brake pedal, move the gear select..
To access the front screw thread:
Unclip the cover by pressing at its top lefthand
corner.
Release the cover.
To be towed:
Screw the towing eye in fully.
Install the towbar.
Put the gearbox into neutral.
In the event of a breakdown
Failure to observe this instruction could
result in damage to certain components
(braking, transmission, etc.) and to the
absence of braking assistance..