DS 3: Rear bench seat / Rear head restraints
DS 3 2016-2025 Owners Manual

They have two positions:
- A high position, for when the seat is in use:
- Pull the head restraint fully up.
- A low position, for stowing, when the seat is
not in use:
- Press the lug A to release the head restraint
and push it down.
The rear head restraints can be removed.
Removing a head restraint

- Release the backrest using control 1.
- Tilt the backrest slightly forwards.
- Pull the head restraint fully up.
- Press the lug A to release the head restraint
and remove it completely.
Refitting a head restraint
- Insert the head restraint rods into the guides
in the corresponding backrest.
- Push the head restraint fully down.
- Press the lug A to release the head restraint
and push it down.
Never drive with
passengers seated at the
rear when the head restraints are
removed; the head restraints should be in
place and in the high position.
The head restraint for the centre seat
and those for the outer seats are not
interchangeable.
Manoeuvring the backrests should only be
done when the vehicle is stationary.
First steps:
Lower the head restraints.
If necessary, move the front seats forward...
Other information:
Scan the QR Code on page 3
to view
explanatory videos.
Made up of a compressor and a sealant
cartridge, it allows you to carry out a temporary
repair of the tyre so that you can drive to the
nearest garage.
It is designed to repair most punctures located on
the tyre tread...
Switching on the ignition without starting the engine
With the electronic key in the passenger
compartment, pressing the "START/STOP" button,
without depressing any of the pedals, allows the
ignition to be switched on without starting the
engine.
Press this button again to switch off the
ignition and allow the vehicle to be locked...