DS 3: Towing the vehicle / Towing another vehicle

DS 3 2016-2026 Owners Manual

To access the rear screw thread:

DS 3. Towing another vehicle

Unclip the cover by pressing at its left-hand section.
Pull the cover downwards.

To tow:

Screw the towing eye in fully.
Install the towbar.
Switch on the hazard warning lamps on both vehicles.
Move off gently, drive slowly and only for a short distance.

Towing your vehicle

To access the front screw thread: Unclip the cover by pressing at its top lefthand corner. Release the cover. To be towed: Screw the towing eye in fully...

Other information:

DS 3 2016-2026 Owners Manual: Checking/adjusting tyre pressures

The compressor can be used, without injecting sealant, to check and, if necessary, adjust the tyre pressures. Remove the valve cap from the tyre and keep it in a clean place. Uncoil the pipe stowed under the compressor. Screw the pipe onto the valve and tighten firmly. Check that the compressor switch is in position "O". Fully uncoil the electric cable stowed under the compressor. ..

DS 3 2016-2026 Owners Manual: Towing

Driving with a trailer places greater demands on the towing vehicle and particular care must be taken. Do not exceed the maximum towable weights. At altitude: reduce the maximum load by 10% per 1,000 metres of altitude; the lower air density at high altitudes decreases engine performance. New vehicle: do not tow a trailer until the vehicle has driven at least 620 miles (1,000 kilomet..

Principle of operation

DS 3. Principle of operation

Using the rear camera, the vehicle's close surroundings are recorded during manoeuvres at low speed.